Milwaukee 48-59-2818 User Manual download pdf (Page 3)

MILWAUKEE ELECTRIC TOOL CORPORATION

13135 WEST LISBON ROAD • BROOKFIELD, WISCONSIN 53005 USA

(262) 781-3600

Pack

connected to

Charger with

alternately

flashing

red/green

Charger lights.

Bad connection between Battery

Pack and Charger

Faulty Battery Pack

Battery Pack temperature dropped

below 14ºF during charge

Pack temperature higher than

194ºF at start of charge

Incorrect Battery Pack type for

Charger

Water inside Battery Pack or

Charger as a result of condensation

from bringing cold product into a

warm environment

Unknown transient condition - could

be caused by Battery Pack or

Charger

Clean Battery Pack terminals. Visually Check Battery Pack terminals

inside connector block. If any terminals are out of position open Charger

and push terminal(s) into connector block to re-seat terminals. NOTE:

Before checking battery pack terminals inside connector block or if

servicing the power cord, unplug the Charger from power source and let it

sit for 3-4 minutes before disassembling – this allows circuit board

capacitor to self discharge.

Pack may not be accepting charge or Battery Pack electronics may be

faulty. Attempt to charge Battery Pack on known-good Charger.

Move Charger and Battery Pack to warmer environment. Allow to warm

up, and then re-start charge.

Allow Battery Pack to cool to appropriate temperature range (below

150ºF) before attempting to charge.

Use appropriate Battery Pack.

Allow Battery Pack or Charger to dry out.

Remove and re-insert Battery Pack several times. Try known-good

Battery Pack on Charger.

—

™-

Y LITHI

M-I

ROU

BLE

TIN

IDE

—

1 2 3 4 5 6

O INFORM YOU 1
(262) 781-3600 3

Comments to this Manuals

No comments

Milwaukee 48-59-2818 User Manual Page 3

Comments to this Manuals

Related products and manuals for Battery chargers Milwaukee 48-59-2818