Milwaukee LSVFSD-LP User Manual

Report No.116-L-49-5INSTALLATION AND OPERATION INSTRUCTIONSDo not store or use gasoline or other flammable vapors or liquids in the vicinity of this or

10NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.LOG PLACEMENT INSTRUCTIONS1. Place rear ember bed as shown in Figure 11.Figure 11 - Install Rear E

11NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.7. Place the right top log onto rear log locating pin and the right front log locating pin as show

12NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.Top Burner Air Shutter Adjustment Procedure1. If you have blue flame or the top burner is not carry

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.13An expanded view of the appliance with numbered parts and a parts list can be found on Page 19. A

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.14Standard Remote Control System (Model RCL)The Model RCL (Standard) Remote Control System, fe

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.15ACCESSORY COMPONENTS (CONTINUED)* For use with gas train models LSVFSD-NG and LSVFSD-LP only18&quo

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.16* For the purpose of input adjustment.PILOT (O.D.S.)ASSEMBLYTHERMOPILEWHITEWHITEWHITEREDMILLIVOLT

174. Depress gas control knob slightly and turn clockwise to “OFF.” Do not force.5. Close lower control compartment.LIGHTING INSTRUC

18VENTED/UNVENTED TROUBLESHOOTING GUIDEOBSERVED PROBLEM POSSIBLE CAUSE REMEDY1. When igniter button is pressed, there is no spark at ODS/pilot.A. I

19NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.REPLACEMENT PARTS LIST (MILLIVOLT) - SHADOWDANCE™ SERIESReplacement Parts List (Millivolt) - Shado

2IMPORTANT SAFETY AND WARNING INFORMATIONREAD THIS MANUAL IN ITS ENTIRETY AND UNDER-STAND THESE RULES TO FOLLOW FOR SAFETY. WARNINGSIf the informa

FPOLennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to disc

3NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.These Gas Log Appliances incorporate unitized ceramic fiber logs which provides some glow realistica

4Adhere to all local codes or in their absence the latest edition of The National Fuel Gas Code ANSI Z223.1 or NFPA 54-latest edition which can

5This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and vent

6Note: Illustrations shown in this manual reflect “typical” installations with nominal dimensions and are for reference only. Actual installation

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.7Figure 3Step 2. Ceiling Clearance: The ceiling must be at least 42" from the top of the applia

8NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.Any outside air ducts and/or ash dumps in the fireplace shall be perma-nently closed at time of appl

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.9The appliance gas inlet connection is 3/8" NPT at the regulator/valve, located on the left sid