LUBRICATION NOTES:
Type ‘L’ Grease
No. 49-08-4175, 1 lbs. can
Type ‘P’ Grease
No. 49-08-4250, 1-1/2 oz. tube
2
1
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2
1
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
18
19
17
Place 5 grams (approx. 3/16 ounce) of Type ‘L’ grease in the upper
left corner of gearcase support assembly.
Apply a thin coat of ‘L’ grease around and in the drive shaft bushing.
Apply a thin coat of ‘L’ grease to area shown. Be sure to cover the
roller carrier slot and the surfaces the roller pin will have contact with.
Coat the cam pocket of the gearcase support with ‘L’ grease.
Place 5 grams (3/16 ounce) of ‘L’ grease in carrier pin pocket.
Coat the release slide slot in gearcase support with ‘L’ grease.
Apply a thin coat of ‘L’ grease to the roller pin prior to assembly with
the carrier and roller.
Coat the top and bottom surfaces of the carrier with ‘L’ grease.
After assembly in the carrier with the pin, add 3 grams (approx. 1/8
oz. of ‘L’ grease to the surface of the roller.
Apply a thin coat of ‘L’ grease to all surfaces of the follower pawl.
Be sure to cover shaft, release surfaces and ratchet locking
surfaces.
Apply a thin coat of grease to all surfaces of the release slide.
Fill gear teeth and both side spring pockets of the ratchet with ‘L’
grease. Once the two return springs are inserted, apply a thin
coat of grease over all ratchet surfaces.
Apply a thin coat of ‘L’ grease to the holes and outside edges of
the right and left drive links of the ratchet and pawl assemblies.
Be sure the drive pawl release lever is coated with grease also.
Place 5 grams (3/16 ounce) of ‘L’ grease in carrier pin pocket.
Apply a thin coat of ‘L’ grease to area shown. Be sure to cover the
roller carrier slot and the surfaces the roller pin will have contact
with.
Coat the cam pocket of the gearcase support with ‘L’ grease.
Place a thin layer of ‘L’ grease to the inside walls of the gearcase
cover bushing and follower pawl shaft hole. Apply a thin coat of
grease to the area outside the bushing.
Apply a thin coat of Type ‘P’ grease to the ring gear pocket of the
gearcase support assembly.
Apply a thin coat of Type ‘P’ grease to the ring gear pocket of the
gearcase cover.
Place a thin coat of ‘P’ grease to the gear components shown
above. Be sure that all ring gear teeth and planetary gear teeth
are completely covered.
When servicing, remove 90-95%
of the existing grease prior to
installing Type 'L' or 'P' grease.
Original grease maybe similar in
color but not compatible with the
service lubricants.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals