Milwaukee 6019 Operator's Manual download pdf (Page 5)

page 5

TOOL ASSEMBLY

Attaching Sandpaper Discs

Cat. No. 6018 is designed to be used with sanding discs that have a PSA

(pressure sensitive adhesive) backing. Cat. No. 6019 is designed to be

used with sanding discs that have a hook and loop backing.

1. Unplug tool and place it on a flat surface with pad up.

2. For Cat. No. 6018, clean dust and debris from pad face with a dry

cloth. Do not use solvents or immerse pad in liquids as this may

damage the pad.

3. Align holes in sandpaper with the dust extraction holes in the sand-

ing pad and firmly press the sandpaper onto the pad.

NOTE: Sanding disc sizes vary. Choose a sanding disc between

4-3/4" to 5" in diameter.

To secure the sanding disc, run the sander on scrap, pressing

down firmly on the sandpaper.

4. To remove the sandpaper disc, peel it away from the pad.

NOTE: When using PSA sanding discs, do not store tool with sand-

paper disc on pad. Due to heat generated while sanding, discs left

on the pad for extended periods may be difficult to remove.

Attaching Dust Bag (Fig. 1)

To attach dust bag, slide bag’s entry port over sander’s dust exit spout

until detent engages with hole in entry port.

To remove dustbag, gently twist entry port and pull it away from dust exit

spout.

For best results, empty dust bag when it is no more than half full. To

empty dust bag, remove bag from sander. Unzip bag and gently tap to

remove dust.

Random Orbit Sanders

Random orbit sanders combine a small orbiting action with free floating

rotation. The resulting motion is a random pattern that produces an even,

swirl-free finish on a variety of materials.

Selecting Sandpaper and Grits

Sandpaper can be made from various grit materials and these should be

selected according the material to be sanded. The guidelines below list

materials and grit materials that should be used with them.

• Fine woodwork - garnet or aluminum oxide

• Rough woodwork - aluminum zirconia or ceramic aluminum oxide

• Manufactured wood products (particleboard, medium density

fiber board etc.) - silicon carbide or aluminum oxide

• Solid surfacing materials (Corian, etc.) - silicon carbide or

aluminum oxide

• Metals - emery or aluminum oxide

Sandpaper is also graded by coarseness. Start your work with an abra-

sive grit just coarse enough to remove high spots and excessive rough-

ness. Follow with a second sanding using a grit one or two grades finer.

Continue with successively finer grits until you obtain the desired finish.

Do not switch from a coarse grit to a very fine grit in one step because it

may be difficult to remove the marks made by the coarse grit abrasive.

Use the finest grits practical for the roughing operation, and finish by

using successively finer grits.

Grit

100

120

150

180

220

Type

Course

Medium

Fine

Typical Application

Ideal for initial sanding on rougher surfaces.

For fast stock removal. Rough sanding and

stripping of painted and rusted surfaces.

For intermediate sanding and removal of

minor surface imperfections.

Ideal for fine sanding prior to staining,

priming or sealing.

Fig. 1

Dust exit spout

Entry port

WARNING!

To reduce the risk of injury, always unplug tool before

attaching or removing accessories or making adjustments.

Use only specifically recommended accessories. Others

may be hazardous.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Milwaukee 6019 Operator's Manual Page 5

Comments to this Manuals

Related products and manuals for Power sanders Milwaukee 6019