Milwaukee 5340-21 Operator's Manual download pdf (Page 10)

page 10

Chiseling and Chipping

These MILWAUKEE Hammers may be used for chipping and chiseling.

When chiseling, hold the tool at an angle to the workpiece. Work from a

corner or close to the edge of the workpiece, breaking off one small area

at a time rather than attempting too large an area.

A variety of accessories are available.

Scaling Chisels

For removing weld spatter or scale and cut-

ting straight lines.

Bushing Tools

Used to surface concrete.

Mortar Cutting Chisels (Seam Tools)

For removing old mortar for tuck pointing or

caulking.

Bull Points

For demolition work and starting holes in

concrete slabs.

Flat Chisels

For edging, chipping or channeling.

Slotting Chisel

For slotting and cutting between drilled holes

in concrete and masonry.

NOTE: If unable to drill a hole in the kerf, pull back on the bit with the ham-

mer running (Fig. 13). This will remove some of the dust and debris from

the cut. Repeat this for every inch of drilling. If necessary, vacuum dust and

debris from the cut and surrounding area.

Fig. 13

Pull bit out as far

as possible once

or twice per inch

drilled.

7. For core bits, once the maximum core bit depth is drilled, the core must

be broken and removed.

• Install a chisel bit.

• Place the chisel into the hole kerf (Fig. 12).

• Chisel down into the kerf at several points until the core is loose or

broken.

• Remove the core and vacuum/remove any remaining dust and de-

bris.

• Install the core bit and continue the cut.

Fig.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Milwaukee 5340-21 Operator's Manual Page 10