Milwaukee 4204-1 Operator's Manual

Catalog Nos.Nos. de Cat.Catálogo Nos.4253-14262-14292-14297-1HEAVY-DUTY DRILL MOTORS, ELECTROMAGNETIC DRILL STANDS,ELECTROMAGNETIC DRILL PRESSE

page 10Attaching MILWAUKEE STEEL HAWG CUTTERSSee the information supplied with your arbor.Cutting Procedure1. Refer to the chart supplied with the ar

page 11Safety ChainCat. No. 48-58-00806ft.HAWG WASH Cutting FluidCat. No. 49-32-0081Maintaining ToolsKeep your tool in good repair by adopting a

page 2GENERAL SAFETY RULES  FOR ALL POWER TOOLSWORK AREA SAFETYELECTRICAL SAFETYPERSONAL SAFETYPOWER TOOL USE AND CARESERVICE4. Power tool plugs mus

page 31. Always use safety chain. Mounting can release when drilling overhead or on a vertical surface (See Safety Chain under Operation

page 41. Rack2. Slide3. Slide locking wing screw4. Drill motor5. Grease fitting6. Gib adjusting screws7. Chuck8. Housing9. Magnet10. Adjusting handle1

page 5Grounded tools require a three wire extension cord. Double insulatedtools can use either a two or three wire extension cord. As the distancef

page 61. Assemble the feed handles and grips to the feed handle hub. Tightensecurely.2. To mount the feed handle to the opposite side, remove t

page 7Control Panel (Fig. 6)Magnetic Holding ForceThe electromagnetic drill press attaches magnetically to any ferrousmetal. It is designed for

page 8The gear shift on the drill motor is labeled:L - for low speedH - for high speedTypical Operation1. Insert the bit into the chuck or socke

page 9DrillingWhen preparing to drill, align the bit with the spot to be drilled. Whenproper alignment is established, energize the magnet and s