Milwaukee 4204-1 Operator's Manual download pdf (Page 6)

page 6

1. Assemble the feed handles and grips to the feed handle hub. Tighten

securely.

2. To mount the feed handle to the opposite side, remove the wing

screw assembly that secures the hub/pinion assembly. Pull out the

hub/pinion assembly and insert on the other side of the housing.

Replace and tighten the wing screw assembly.

Mounting the Drill on Slide (Fig. 2)

Attaching Feed Handles and Grips (Fig. 1)

Adjusting the Gib Assembly (Fig. 3)

To adjust the gib, loosen or tighten the gib adjustment set screws on the

side of the support housing accordingly with the 3/32" hex key provided.

Tightening the set screws increases friction on the slide. The gib should

be set tight enough to support the weight of the drill in any position. All

adjusting screws should be set to provide smooth and even travel over

the entire length of slide movement.

The set screws contain a nylon patch that prevents them from moving

freely. Additional adjustment of the gib may be required from time to time

with extended use of the tool.

Connecting the Power Cord Control Panel Socket (Fig. 4)

To reduce the risk of injury, always unplug the tool before

changing accessories or making adjustments.

WARNING!

ASSEMBLY

To provide maximum holding power, mount the motor with the spindle

closest to the stand. All drills (except 4253-1) can also be mounted in a

reverse position to permit drilling close to walls and corners. When the

spindle is furthest from the stand, the maximum drill point pressure is

reduced.

1. Select the mounting area that best suits your application.

2. Line up the mounting holes.

3. Slip the lock washers over the mounting screw and insert them

through the back of the slide and into the motor mounting pad. Tighten

securely.

Insert the drill plug into the control panel socket and screw it on tightly.

Plug the drill press into the nearest power source. This drill press is rated

for 120 volts AC, 60 Hz.

Fig. 2

Fig. 3

Fig. 4

Fig. 1

1 2 3 4 5 6 7 8 9 10 11

No comments

Milwaukee 4204-1 Operator's Manual Page 6