Milwaukee M12 IR Operator's Manual download pdf (Page 10)

8 M12 160x120 Thermal Imager Operator’s Manual

3. To remove it, press it in gently and it releases so you

can pull it out.

4. If an SD card is not installed, insert the SD card with

the label facing the front of the Thermal Imager (the

side with the lens). It ts only one way. Do not use

excessive force.

5. Gently press it until the SD card clicks and locks in

place. Press it again to release it. Leave it locked into

place and close the rubber dust and water cover.

Figure 3. Installing the SD Card



Read and understand the warnings and instructions in the

Battery Charger Operator’s Manual. Charge the battery

until the green indicator on the Battery Charger appears. It

takes approximately 30 minutes to reach a full charge with

the supplied M12 battery. Any MILWAUKEE M12 Series

battery will work with the Thermal Imager.

To avoid damage or injury, use only a genuine

MILWAUKEE M12 battery and charger, and follow the

charging and handling instructions supplied with the Battery

Charger. Snap the battery into place until it locks into the

Thermal Imager’s hand grip as shown in Figure 4.



The SD card is installed in the Thermal Imager at the

factory. The Thermal Imager does not store any images

without one installed.

To remove and re-install the SD card, refer to Figure 3 and

proceed as follows:

1. Flip open the rubber dust and water cover toward the

front of the Thermal Imager.

2. If an SD card is already installed, you will see it in the

upper half of the area under the rubber cover.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

Milwaukee M12 IR Operator's Manual Page 10